#define SetNXTServoPosition ( _port,
_i2caddr,
_servo,
_pos,
_result   )     __MSWriteLEIntToRegister(_port, _i2caddr, _reg, _pos, _result)

Set NXTServo servo motor position.

Set the position of a servo motor controlled by the NXTServo device. The port must be configured as a Lowspeed port before using this function.

Parameters:
_port The sensor port. See NBC Input port constants.
_i2caddr The sensor I2C address. See sensor documentation for this value.
_servo The servo number. See MindSensors NXTServo servo numbers group.
_pos The servo position. See MindSensors NXTServo position constants group.
_result A status code indicating whether the operation completed successfully or not. See TCommLSCheckStatus for possible Result values.

Generated by  doxygen 1.6.2